46
TruVision IP PTZ Camera Configuration Manual
face looking directly into the camera, not side views. This feature is best suited when
the camera is in front of a door or is located in a narrow corridor.
To set up face detection:
1. From the menu toolbar, click
Camera Configuration > Alarm/Event Setup> Face
Detection
.
2. Select
Enable Face Detection
.
3. Select
Enable Dynamic Analysis for Face Detection
if you want the face detected
to be marked with a green rectangle in live view.
Note: if you do not want the detected face marked with the green frame, select
Disable
from
Local Configuration > Browser Configuration > Live View
Parameters > Enable Meta Data Overlay
.
4. Configure the sensitivity of the face detection. The range is between 1 and 5.
5. Set the arming schedule for the face detection. The arming schedule configuration is
the same as that for motion detection. See “Motion detection alarms” on page 39 for
more information.
6. Select the actions to be used for the face detection. The options are:
Notify Surveillance Center
Send an exception or alarm signal to remote management
software when an event occurs.
Send Email
Sends an email to a specified address when there is a motion
detection alarm.
Содержание TruVision TVP-5104
Страница 1: ...TruVision IP PTZ Camera Configuration Manual P N 1073399 EN REV A ISS 15MAY18...
Страница 82: ......
