Interlogix TruVision TVP-5104, Руководство по настройке

Страница: 50 / 82

48 TruVision IP PTZ Camera Configuration Manual
Sensitivity: The sensitivity value defines the size of the object that can trigger the
alarm. When the sensitivity is high, a small object can trigger the alarm. The range
is between 1 and 100.
Detection Target: You can select Human, Vehicle, or All (Human &Vehicle) as the
detection target from the dropdown list. If Human is selected, only people will be
identified as detection objects. If Vehicle is selected, only vehicles will be identified
as detection objects.
5. Set the arming schedule for the intrusion detection. The arming schedule
configuration is the same as that for motion detection. See “Motion detection
alarms” on page 39 for more information.
6. Select the actions to be used for the intrusion detection. The options are:
Notify Surveillance Center Send an exception or alarm signal to remote management
software when an event occurs.
Send Email Sends an email to a specified address when there is a motion
detection alarm.
Upload to FTP/Memory
Card/NAS Capture the image when an alarm is triggered and upload the
picture to NAS or FTP server.
Intelligent Tracking Triggers the intelligent tracking function
Trigger Recording Triggers the recording to start in the camera.
Trigger Alarm Output Trigger external alarm outputs when an event occurs. Select
one of the options: Select Trigger Alarm Output, A->1, or A-
>2.
Note: This option is only supported by cameras that support
alarm output.
7. Click Save to save changes.
Line crossing detection
This function can be used to detect people, vehicles and objects crossing a pre-defined
line or an area on-screen. The line crossing direction can be set as unidirectional or
bidirectional. Unidirectional is crossing the line from left to right or from right to left.
Bidirectional is crossing the line from both directions.
A series of actions can be triggered if an object is detected crossing the line.
To set up line crossing detection:
1. From the menu toolbar, click Camera Configuration > Alarm/Event Setup> Line
Crossing Detection .