Interlogix TruVision DVR 40, Руководство пользователя

Страница: 60 / 122

54 TruVision DVR 40 User Manual
2.
To select the motion detection zone(s)
a. Go to the
Zone
setup button and press Enter or left-click the mouse. The Motion Zone
setup screen appears.
There is a solid white pane on-screen. The motion zone setup steps are the same as
those for mask zone setup (see page 57).
b.
Front panel/IR remote control:
Use the following buttons to setup the motion zones:
Front panel
buttons
IR remote
control buttons
Action
, , , , , ,
Move the white pane to any position
F1 Analog
Toggle between the white (deactivate) and grey (activate) panes
When the square is grey (activated) increase the size of the
transparent zone when moved left to right
When the square is grey (activated) decrease the size of the
transparent zone from the right to left
When the square is grey (activated) increase the size of the
transparent zone from up to down
When the square is grey (activated) decrease the size of the
transparent zone from down to up
F2 IP
Select the whole screen as a motion zone
F2 IP
Clear all motion zones
Enter OK
Save changes and return to the Camera menu
Menu Menu
Cancel setup and return to the Camera menu
Move the white square to the area on-screen that you want to mark as a motion detection
zone. Press F1. The square becomes transparent. This shows the selected square is
activated and will detect motion.
Use the arrow buttons or drag the square with the mouse cursor in a left-to-right or up-to-
down direction to extend the transparent square. When you have finished marking out
the transparent zone to be masked, press Enter to exit and return to the solid white
square to continue masking.
Mouse
: Position the mouse cursor at the top of the zone to be activated for motion
detection. Drag the cursor in a left-to-right or up-to-down direction to extend the
transparent square.
c. Repeat step b for each zone on-screen where you want to detect motion. An example of
motion detection zones is shown below.