P/N 144200999-
2 (ML) • REV D • ISS 29MAR19
3 / 10
6
EN: Installation Sheet
Description
The AS520 series siren is an outdoor siren with two beacons.
Wiring
First, wire the control panel (power down) to the siren as
shown above, before connecting the battery. When the battery
is connected for the first time, the siren will give a short beep.
The siren cannot be activated until all inputs (input power and
hold-off voltages) are correct. The siren will be activated if the
input power is removed or drops significantly or if the siren
hold-off voltage is removed.
Specifications
Supply*
10.0 to 14.5 V
Current
Standby
Operating
40 mA typical
350 mA typical (including beacon)
Sound output
114 dB at 1 m, 85 dB at 3 m
Frequency
1.8 to 3 kHz
Cut-off timer
Preset at 3 min
Adjustable 5, 10, 20 min
Battery:
Type
Load voltage
Lead acid, BS121N, 12 V, 1.2 Ah
13.6 to 14.2 V
Tamper
28 V
, 100 mA max.
Weight
1 kg
Dimensions
210 x 300 x 70 mm
Working temperature
−25 to +55°C (no battery)
0 to +40
°C (with battery)
Beacon
Operating current
110 mA
Light output
100.000 peak lumens
Life time
1.000.000 flashes
Flash rate
60/minute
Spike suppression
network
Standard fitted
*
To be connected to an external current limited power supply.
(Advised: 5 A).
Battery removal/disposal
This product may contain one sealed, rechargeable, BS-type
lead-acid battery. Because removing batteries may affect the
product's configuration settings or trigger an alarm, only a
qualified installer should remove them.
To remove the battery:
1. Make sure that your product settings allow you to open its
cover without starting the tamper alarm.
2. Switch off the mains power, if necessary, and remove the
cover.
3. Disconnect battery connectors.
4. Remove the battery from the holder.
For proper recycling, dispose of all batteries as required by
local ordinances or regulations.
WARNING:
Danger of explosion if battery is incorrectly
replaced. Replace only with the same or equivalent type
recommended by the manufacturer.
Regulatory information
Manufacturer
PLACED ON THE MARKET BY:
UTC Fire & Security Americas Corporation, Inc.
3211 Progress Drive, Lincolnton, NC, 28092, USA
AUTHORIZED EU REPRESENTATIVE:
UTC Fire & Security B.V.
Kelvinstraat 7, 6003 DH Weert, Netherlands
Certification
Product warnings
and disclaimers
THESE PRODUCTS ARE INTENDED FOR SALE
TO AND INSTALLATION BY QUALIFIED
PROFESSIONALS. UTC FIRE & SECURITY
CANNOT PROVIDE ANY ASSURANCE THAT
ANY PERSON OR ENTITY BUYING ITS
PRODUCTS,
INCLUDING ANY “AUTHORIZED
DEALER” OR “AUTHORIZED RESELLER”, IS
PROPERLY TRAINED OR EXPERIENCED TO
CORRECTLY INSTALL FIRE AND SECURITY
RELATED PRODUCTS.
For more information on warranty disclaimers and
product safety information, please check
https://firesecurityproducts.com/policy/product-
warning/
European Union
directives
UTC Fire & Security hereby declares that this
device is in compliance with the applicable
requirements and provisions of the Directive
2014/30/EU and/or 2014/35/EU. For more
information see www.utcfireandsecurity.com or
www.interlogix.com.
Содержание AS520 Series
Страница 10: ...10 10 P N 144200999 2 ML REV D ISS 29MAR19...
