Chapter 6 - GLZ Graphics 75
➤
To replace a GLZ2 module:
1.
Using a quarter-inch nutdriver, remove the screws securing the
module to the chassis. Retain the screws.
2.
Remove the module from its slots.
3.
Install the new GLZ2 module into the same slots from which the other
module was removed.
4.
Secure the module to the chassis using the screws removed previously.
Geometry Accelerator
A Geometry Accelerator board, installed in PCI slot 1, is only used in the
GLZ3 and GLZ5 options.
➤
To replace a Geometry Accelerator board:
1.
Using a quarter-inch nutdriver, remove the screw securing the
Geometry Accelerator board to the chassis. Retain the screw.
2.
Disconnect the FIFO status cable. Note the pins on the Geometry
Accelerator board to which the FIFO status cable is connected. The
cable must be installed on the same pins of the new Geometry
Accelerator board.
FIFO Status
Cable
Geometry
Accelerator
Board
GLZ3
Board
Содержание TDZ-300
