Intergraph TD-x10 Setup, Справочное руководство системы

Страница: 20 / 98

10
2. Remove the screws holding the drive to each side of the chassis. Slide the drive and its support
bracket out of the base unit.
3. Remove the support bracket from the drive. Mount the replacement drive to the support bracket
using the screws removed previously.
4. Install the drive and its support bracket into the base unit.
5. Connect the cables to the drive. On a combo drive, connect the floppy drive cable to the connector
on the side of the device.
CD-ROM Drive
To replace the CD-ROM drive:
1. Remove the floppy disk drive or combo drive as described previously in step 2 of “Floppy Disk
Drive or Combo Drive,” leaving the cables attached.
2. Disconnect the cables from the CD-ROM drive. Refer to the following figure.
Power
Cable
SCSI
Cable
Audio
Cable
Screws
CD-ROM
Drive
3. Disconnect the audio cable from its system board connector.
4. Remove the screws holding the CD-ROM drive to each side of the chassis.
5. Slide the CD-ROM drive forward and out of the base unit.
6. Disable SCSI termination and set the SCSI ID. Refer to the vendor’s CD-ROM drive
documentation for instructions.
7. Insert the new CD-ROM drive through the front panel.
8. Secure the CD-ROM drive to the chassis using the screws removed previously.
9. Connect the SCSI cable and power cable to the CD-ROM drive. The SCSI cable is keyed to
ensure proper insertion, so that the red stripe (pin 1) is adjacent to the power connector.
10. If installing an Intergraph CD-ROM drive, the audio cable is already connected to the drive.
Connect the loose end of the audio cable to the system board connector.