Intergraph InterServe 600 Series, Справочное руководство системы

Страница: 45 / 104

35
The total length of the SCSI cabling is the sum of the following:
u
SCSI cable inside the base unit - 6.0 inches (15 cm)
u
SCSI cable inside each device - average 8 inches, (20 cm)
u
SCSI cable between the base unit and the first device
u
SCSI cable between each device
To install an external SCSI device:
1. Set the device’s SCSI ID to an unused number and enable or disable the device’s SCSI termination
according to the note above and the vendor’s instructions.
2. Connect one end of the SCSI cable to the Fast SCSI-2 port on the back of the base unit. If external
devices are already installed, connect the SCSI cable to the available SCSI port on the last device
on the SCSI cable chain.
3. Connect the device to the other end of the SCSI cable.
4. If necessary, install the device drivers and configure the device according to the vendor’s
instructions.
Adding Option Boards
This section briefly describes the differences between Peripheral Component Interconnect (PCI), ISA,
and Plug-n-Play (PnP) option boards. Instructions are also provided for installing option boards into
the system.
Option boards are installed on the riser card. PCI boards connect to side one of the riser card, while
ISA and PnP boards can be installed on side two. The following figure shows the slots on the riser
card.
NOTE PCI slots 1 through 4 are on the secondary PCI bus. PCI slots 5 and 6 are on the primary PCI bus.
PCI 6
PCI 5
PCI 4
PCI 3
PCI 2
PCI 1
Side One Side Two
ISA 2
ISA 3
ISA 1
ISA 4