Intergraph InterServe 600 Series, Справочное руководство системы

Страница: 20 / 104

10
5. If replacing a disk drive (located above the CD-ROM drive), remove the bracket from the drive.
Refer to the following figure.
Slide
Bracket
Screw
6. Disable SCSI termination and set the SCSI ID on the back of the drive to the same ID as the drive
being replaced. If necessary, refer to the documentation delivered with the SCSI drive for
instructions.
7. If installing a hard disk drive, attach the drive to the bracket.
8. Insert the new SCSI drive through the front panel.
9. Secure the SCSI drive using the screws removed previously.
10. Connect the SCSI cable, power cable, and audio cable (CD-ROM drive only). The SCSI cable red
stripe (pin 1) must be adjacent to the power connector.
Note If installing a non-Intergraph CD-ROM drive, use the audio cable delivered with the new CD-ROM drive.
11. Close the base unit.
Combo Drive (MESAM86)
To replace the combo drive:
1. Open the base unit and remove the necessary parts as described in Chapter 1.
2. Remove the CD-ROM drive as described previously in “Internal SCSI Drives.”
3. Using a quarter-inch nutdriver, remove the screws from both sides of the combo drive as shown in
the following figure. Then slide the drive out of the base unit.