Intergraph DHAF02430, Справочное руководство системы

Страница: 34 / 98

24
Supported Memory Bank 0 Bank 1 Bank 2 Bank 3
2 x 64 MB 2 x 64 MB NP NP
2 x 32 MB 2 x 32 MB 2 x 32 MB 2 x 32 MB
512 MB 2 x 128 MB 2 x 128 MB NP NP
2 x 64 MB 2 x 64 MB 2 x 64 MB 2 x 64 MB
1 GB 2 x 128 MB 2 x 128 MB 2 x 128 MB 2 x 128 MB
To install the memory upgrade:
1. Open the base unit and remove the necessary parts as described in Chapter 1.
2. Remove the graphics boards and other installed PCI option boards.
3. Remove the existing SIMMs from their sockets before adding new ones.
4. Remove the SIMMs from the antistatic bag and install them in the following order:
−
For system board MSMT353 or MSMT359, if the total number of installed SIMMs will be
four, install the SIMMs in the Bank 1 sockets first, then in the Bank 0 sockets.
−
For system board MSMT353 or MSMT359, if the total number of installed SIMMs will be
eight, install the first SIMM in socket J58. Install the remaining SIMMs in the next empty
socket until socket J51 is the last socket populated.
−
For system board MSMT378, install the first SIMM in the first available socket.
5. Position the SIMM in the next available socket so that the notch faces the back of the base unit.
6. Insert the SIMM at a 60 degree angle, pressing it firmly into the socket.
7. Push on the top edge of the SIMM until it snaps into the metal clips. The socket tabs must fit
inside the mounting holes of the SIMM.
8. Repeat steps 5 through 7 for the remaining SIMMs.
9. Replace the graphics and PCI option boards and close the base unit.
10. Restart the system. The new memory is recognized automatically.
Adding Processors to MSMT353 or MSMT359
You cannot add processors to the MSMT353 system board, since it ships with quad processors. The
MSMT359 system board allows you to upgrade a single processor to dual processors and dual
processors to quad processors. For the MSMT378 system board, you can upgrade a single processor
to dual processors and Pentium Pro to Pentium II.