Interactive Technologies SceneStation, Руководство пользователя

Страница: 92 / 96

86 | Appendix D: Self Test Mode SceneStation Installation and Programming Guide
Testing Pushbutton Switches
Whenever any button on the station is pressed, the LEDs on
that button switch to Full White while all other LEDs on the
station continue to cycle their colors, but at a reduced bright-
ness level.
If a button is not pressed, and the station is showing one
or more buttons in White while the other buttons are dimly
cycling colors, this means that those buttons may be stuck
down or are defective.
If a button is pressed, and the station does not light up the
button in White, this means that the button is not being
detected properly and is defective.
Note: If an active DMX Input source is attached to the station, the Button Test will not function. See
the “Testing DMX Input” section below.
Note: Don’t press the Top and Bottom buttons on the station simultaneously, as this combination will
exit the Self Test mode.
Testing DMX Output
While the Self Test mode is operating, the station continuously outputs a DMX signal that matches
the colors of the buttons.
If RGB LED lighting fixtures are attached to the station, these fixtures will output the same colors that
the buttons are displaying. If a button is pressed on the station, the intensity of the DMX fixtures will
reduce just like the brightness of the buttons.
Any other DMX fixtures can be attached to the station as well. Dimmers or other fixtures will output a
pattern that matches the color cycle that the buttons are displaying.
Keep in mind that the DMX test signal might not produce a “pretty” scene on your specific fixtures,
the idea is to verify that the station is sending a signal that the fixtures can understand.
Note: If an active DMX Input source is attached to the station, the DMX Output Test will not function.
See the “Testing DMX Input” section below.
Testing DMX Input
If a valid DMX Input signal is attached to the station, the LED indicators switch to a special mode that
shows the value of the first 15 channels received by the station. This mode overrides all other display
modes of the LEDs.
Channels 1, 2 and 3 operate the Red, green and Blue components of Button 1. Channels 4, 5 and 6
operate the RGB components of Button 2, and so on.
NOT PRESSED
All LEDs Cycling
Colors
PRESSED
Button 3 White
Other LEDs Dim