I N S T A L L A T I O N M A N U A L
X - S T R E A M ™ S L I D E
12
XS-IM Rev. 7/08 (SBK-XS INSTALL)
STEP FOUR:
Attach the Feet to the Legs
TIP:
Do not confuse the (4) foot holes at the bottom of the leg with the (4) leg receiver holes
at the top. The foot holes are 4.5” from the bottom of the leg, and the leg sits flush to the
deck when it is attached correctly.
Insert the bottom of the long leg onto the foot, align the holes, utilizing hardware kit XS-101-SS,
place a flat washer over a 3/8” bolt; then push bolt through the pre-drilled holes in the PVC
leg and the foot, then place flat washer then 3/8” nylon nut and tighten. Repeat the
process for the short leg.
STEP FIVE:
Assemble the Flume Sections
TIP:
Assemble the flume sections on the ground. Be careful not to scratch the slide; use
the cardboard box for protection. Hand tighten the flume bolts for now, they will be fully
tightened once the flume is correctly aligned.
Right Turn or Left Turn Assembly:
The flumes are labeled A, B or C, D in small letters on the flanges without the gaskets.
To assemble a
Left Turn
slide: flume A, B will be the upper flume and C, D will be the lower
flume, assembled in that order.
To assemble a
Right Turn
slide: flume C,D will be the upper flume and A, B will be the lower
flume, assembled in that order.
TIP:
There are 3 factory installed gaskets. Ensure that a gasket is in place on the entry
section, and the male end of both flume sections.
Utilizing hardware kit XS-102-SS, attach the lower flume to the upper flume. Align the four
holes in the flange, push 3/8” bolt through a flat washer, then through the pre-drilled holes
in the flanges, then push bolt through a flat washer, then a lock washer and through a 3/8”
nut. Hand tighten at this time.
Fig. 10
Fig. 11
Fig. 12
