I N S T A L L A T I O N M A N U A L
X - S T R E A M ™ S L I D E
8
XS-IM Rev. 7/08 (SBK-XS INSTALL)
LIST OF REQUIRED TOOLS
Tools required for assembly and installation of X-Stream slide:
NOTE: USE PROVIDED ANTI-SEIZE ON ALL BOLTS!
1. Hammer
2. 3/8" drive ratchet
3. 3/8" x 6" ratchet extension
4. 1/2" deep socket (deep socket is necessary)
5. 9/16" socket
6. 9/16" box end ratchet wrench
7. Drill with 3/8" masonry bit
8. Tape measure
9. PVC Pipe Cutter
ASSEMBLY AND INSTALLATION INSTRUCTIONS
For left hand slides, flume A, B is the upper flume and C, D is the lower flume, in that order.
For right hand slides, flume C, D is the upper flume and A, B is the lower.
STEP ONE:
Attach Ladder Foot to Ladder
TIP: The leg foot (elephant foot) for the ladder has a slant inside, the other 2 feet
do not slant. The ladder foot only utilizes 3 bolts while the other 2 feet utilize 4 bolts.
TIP: Use the provided anti-seize on all the bolts used to assemble this slide or the nuts
may seize.
Utilizing hardware kit XS-101-SS, attach the ladder foot to the ladder using (2) 3/8” x 2.5”
bolts and (1) 3/8” x 2.5” bolt. The longer bolt location is just below the water supply hose
hole located at the bottom of the ladder. (See Fig. 1) Place a flat washer over a 3/8” bolt;
then push bolt through the pre-drilled holes in the PVC ladder and ladder foot, then place
flat washer then 3/8” nylon locking nut and tighten.
Fig. 1
