I N S T A L L A T I O N M A N U A L
X - S T R E A M ™ S L I D E
18
XS-IM Rev. 7/08 (SBK-XS INSTALL)
Fig. 23
Example of Slide Foot on Concrete Pad
(Side View)
CONCRETE
24” min.
Layer of setting
material to
secure pavers
to concrete.
PAVERS
3”
max.
Drawing Is
NOT To Scale
HEIGHT OF WEDGE
ANCHOR ABOVE
FINAL DECK
SURFACE
When installing an Inter-Fab X-Stream™ slide using a paver kit, you must ensure that all
standard installation requirements are met. The slide must be compatible with the type of
pool on the intended installation and all ANSI/NSPI-2003 requirements must be met.
Refer to installation manual.
Figure 24 illustrates an example of the minimum concrete pads recommended for the
X-Stream™ slide. Specific slide positions and concrete pad orientations may vary. Make
sure to allow for water stub up location near the ladder foot on the X-Stream™ slide when
pouring the concrete pad for the ladder foot.
In order to ensure proper placement, you
will need to set the slide up first to determine where the concrete pillars will be located.
Figure 23 shows an example side view of a slide foot and an wedge anchor used in a paver
installation. Pavers can be a maximum of 3” thick. Pavers must be mechanically attached
to the concrete pad using a setting material (such as mortar or thinset for example) that
is no thicker than 3/8”.
1” of each 3/8” wedge anchor needs to be exposed above the final deck surface. You will
need to factor in the thickness of your paver (3” MAX.) and the thickness of your setting
material (3/8” MAX.) for your individual installation. For the 1/2” wedge anchors, you will
leave 1-1/4” exposed above final deck surface.
You will need a 3/8” masonry bit for the X-Stream™ slide.
Inter-Fab Inc. will not be responsible for damage to pavers caused by drilling or
mechanically attaching to concrete pad. Refer to paver manufacturer’s specific
installation instructions before beginning.
WEDGE
ANCHORS
Fig. 24
Minimum Concrete Pads – X-Stream™ Slide
(Plan View – NOT to Scale)
Pool Edge
3 concrete pads are needed:
24” wide x 24” long x 24” deep
Center each foot on one pad.
You may
rotate the
square pads
as needed.
X-STREAM™ NOTES:
• All X-Stream™ wedge anchors (12 ea.) are
3/8” x 7”.
• All wedge anchors must be drilled to a depth
of 6” with 1” of the bolt above the final deck
surface.
24” min.
5” min.
from edge
PAVER KIT INFO – X-STREAM
