Intepro systems PSI 9000 2U Series, Руководство пользователя

Страница: 31 / 88

31
PSI 9000 2U Series
PSI 9000 2U Series • DC Laboratory Power Supply • User Manual
1.9.7 USB port (rearside)
The USB-B port on the backside of the device is provided for communication with the
device and for firmware updates. The included USB cable can be used to connect
the device to a PC (USB 2.0 or 3.0). The driver is delivered on the included CD and
installs a virtual COM port. Details for remote control can be found on the Intepro
Systems web site or on the included CD. A general programming introduction for the
USB port is available (date: 07-14-2016)
The device can be addressed via this port either using the international standard
ModBus protocol or by SCPI language. The device recognizes the message protocol
used automatically.
If remote control is active the USB port has no priority over either the interface mod-
ule (see below) or the analog interface. It can only be used alternatively to these.
However, monitoring is always available.
1.9.8 Interface module slot
This slot on the backside of the device (only with standard models, units with option
3W installed are different) is available for various modules of the AnyBus CompactCom
(abbr.: ABCC) type of the IF-AB interface series. The following options are available:
Article No. Name Description
35400100 IF-AB-CANO CANopen, 1x Sub-D 9pole male
35400101 IF-AB-RS232 RS 232, 1x Sub-D 9pole male (null modem)
35400103 IF-AB-PBUS Profibus DP-V1 Slave, 1x Sub-D 9pole female
35400104 IF-AB-ETH1P Ethernet, 1x RJ45
35400105 IF-AB-PNET1P ProfiNET IO, 1x RJ45
35400106 IF-AB-DNET Devicenet, 1x Wago plug 5pole
35400107 IF-AB-MBUS1P ModBus TCP, 1x RJ45
35400108 IF-AB-ETH2P Ethernet, 2x RJ45
35400109 IF-AB-MBUS2P ModBus TCP, 2x RJ45
35400110 IF-AB-PNET2P ProfiNET IO, 2x RJ45
The modules are installed by the user and can be retrofitted without problem. A firmware update of the device may
be necessary in order to recognize and support certain modules.
If remote control is active the interface module has no priority over either the USB port or the analog interface. It
can only be used alternatively to these. However, monitoring is always available.
Switch off device before adding or removing modules!
1.9.9 Analog interface
This 15-pole Sub-D socket on the backside of the device is provided for remote
control of the device through analog signals or switching conditions.
If remote control is active this analog interface can only be used alternatively to the
digital interface. However, monitoring is always available.
The input voltage range of the set values and the output voltage range of the monitor
values, as well as reference voltage level can be switched in the settings menu of
the device between 0-5 V and 0-10 V, in each case for 0-100%.