Intellitec
131 Eisenhower Lane North
Lombard, IL 60148
630 268 0010 / 1 800 251 2408
P/N 53-00778-100 Rev. 062003
www.Intellitecsve.com
Intellitec
Application Installation and Trouble Shooting Guide
Mini-Bus Multiplex System
SWITCH ADAPTER
Part No. 00-00853-000 & 00-00862-000
The Switch Adapter is designed to be used with Carling
Series Switches. A total of six switches can
be used in each Switch Adapter. The 853 switch adapter arranges the 6 switches on 1.00 inch centers. The 862
adapter arranges the switches on 1.03 inch centers and will fit Carling “mounting panels.
When using the adapter with a door module, Lighting output 1 will turn on when the door is open. Lighting
circuit 2 will remain off.
Four of the switches on the adapter are used to control loads such as lighting, wheel chair power and
destination signs. One switch is used to operate one or more doors and a 3-position switch is used to control a
two speed fan.
The Switch Adapter communicates with the various modules in the system and gives the driver control of all the
functions. Two switch adapters with as many as 12 switches can be connected to the minibus system.
Multiplexing allows all 12 switches to communicate over the same wire. The switches do not carry the actual
load current, they simply provide an electronic signal to the Master.
The adapter includes a 4-position dip switch allowing the adapter to be configured in different ways. The dip
switch is located on the rear board of the Adapter.
Dip switch position one is set to
determine which door module and which outputs will respond to the switches. To make the door switch
operate Door module A, set dip switch one to the OFF position.
B, set dip switch one to the ON position. Dip switch one also
Dip switch 2 is used to determine if the door switch will work when ignition is Off . When dip switch two is set to
the on position, the door switch is always active whether ignition is on or not. When set to the off position, the
door switch will only work when ignition is on.
Dip switch three and four are set to make the Aux 1 and Aux 2 outputs go off with the ignition, or stay “hot” for up
to 20 minutes after the ignition is turned off. (If the Aux 1 or Aux 2 rocker switch is left on when ignition is turned
off.)
Contura II
(See the diagram).
See the following and the next page for dip switch settings.
To make the door switch operate Door module
sets the group of channels that the adapter will
“transmit” on. When the switch is set in the ON position it will send on channels 3 through 8 to turn on the 6
outputs of the Auxiliary Output Modules and door module B. When dip switch one is set to the OFF position, it
will send on channels 11 through 16 to turn on lighting 1 and 2 circuits, Aux 1 and Aux 2 on the Master Module,
operate the Fan Speed Module, and Door Module A.
Page 14
Lights 1
Aux 3
Lights 2
Aux 4
Fan Spd
Aux 7 & 8
Aux 1
Aux 5
Aux 2
Aux 6
Door A
Door B
Dip SW 1 Off
Dip SW 1 On
