Intel S2600IP, Технические характеристики продукции

Страница: 77 / 186

Intel® Server Board S2600IP and Intel® Workstation Board W2600CR TPSPlatform Management Overview
Revision 1.1 63
Intel order number G34153-003
Offset Description Event Logging
01h Power supply failure detected
– Asserted if power supply module has failed.
The following codes for failure modes are put into the SEL Event Data 2
byte:

01h - Output voltage fault

02h - Output power fault

03h - Output over-current fault

04h - Over-temperature fault

05h
– Fan fault
The SEL Event Data 3 byte will have the contents of the associated
PMBus* Status register to allow for showing multiple conditions for the
event. For example, Data 3 will have the contents of the
VOLTAGE_STATUS register at the time an Output Voltage fault was
detected. Refer to the
PMBus Specification for details on specific resister
contents
Assertion and
Deassertion
02h Predictive failure
– Asserted if some condition, such as failing fan, has been
detected that is likely to lead to a power supply module failure.
The following codes for warning modes are put into the SEL Event Data 2
byte:

01h - Output voltage warning

02h - Output power warning

03h - Output over-current warning

04h - Over-temperature warning

05h - Fan warning

06h - Under-voltage warning

07h - Input over-current warning

08h - Input over-power warning
The SEL Event Data 3 byte will have the contents of the associated
PMBus* Status register to allow for showing multiple conditions for the
event. For example, Data 3 will have the contents of the
VOLTAGE_STATUS register at the time an Output Voltage Warning was
detected. Refer to the PMBus Specification for details on specific resister
contents.
Assertion and
Deassertion
03h Power supply AC lost
– Asserted if there is no AC power input to power
supply module.
Assertion and
Deassertion
06h Configuration error
– The following codes for configuration errors are put
into the SEL Event Data 2 byte:

01h - The BMC cannot access the PMBus* device on the PSU but its
FRU device is responding.

02h - The PMBUS_REVISION command returns a version number that
is not supported (only version 1.1 and 1.2 are supported for platforms
covered under this FW EAS).

03h - The PMBus* device does not successfully respond to the
PMBUS_REVISION command.

04h
– The PSU is incompatible with one or more PSUs that are
present in the system.
05h
–The PSU FW is operating in a degraded mode (likely due to a
failed firmware update).
Assertion and
Deassertion
4.4.8 System Event Sensor
The BMC supports a System Event sensor and logs SEL event for following events.