Intel P4000RP, Быстрая установка руководство пользователя

Страница: 8 / 18

4
General Installation Process
A
B
Install the Processor ... continued
Components
CAUTION: The underside of the processor has components
that may damage the socket wires if installed improperly.
Processor must align correctly with the socket opening
before installation.
DO NOT DROP processor into socket!
Orient the processor with the socket
so that the processor cutouts match
the two socket pins.
A
Note location of gold key at
corner of processor.
B
D. Install the Processor
Carefully lower the load plate
over the processor.
E. Close the Load Plate
Carefully lower the load plate
over the processor.
A
B
Make sure the front edge
of the load plate slides
under the shoulder screw
as the lever is lowered.
Close the load
plate locking
lever.
A
Load Plate
Front Edge
Shoulder
Screw
F. Engage the Load Plate
A
B
Push down on the locking lever.
Slide the tip of
the lever under
the notch in the
load plate. Make sure the
lever is securely latched.
CAUTION:
DO NOT damage the
server board with the tip of the
locking lever.
Save the
protective
cover.
AA
A
B
H. Remove the Cover
Carefully lift the cover straight up
as shown.
G. Latch the Locking Lever
4
Install Active Heat Sink
A
Align heat sink with holes
in board and lower assembly
to board. Snaps go through
holes in server board.
B
Press downward
on top of cap.
C
Plug the fan cable into the CPU fan header.
E
Fastener snaps
into final position.
D
Repeat B-D for each
fastener in the numerical
order shown at left.
Make sure the screwdriver slot at
the top of each fastener is rotated
perpendicular to the blades of
the heat sink as shown.
Use the following procedure to install an
active heat sink to your server board:
CAUTION: The heat sink has
thermal interface material (TIM) on
the underside of it. Use caution so
that you do not damage the thermal
interface material. Use gloves to
avoid sharp edges.
Note: Heatsink
styles may vary
2
3
1
4
TIM
A
E