Intel® Server System M50CYP2UR Family System Integration and Service Guide
102
6.7.1
Processor Heat Sink Module (PHM) and Processor Removal
Figure 127. PHM Assembly Removal from Processor Socket
1.
Power off the system and disconnect the power cable(s).
2.
Remove the system top cover (see
Section 6.1.1
).
3.
Remove the air duct (see
Section 6.2.1
4.
Ensure all four heat sink anti-tilt wires are in the outward position (see Letter A).
5.
Then fully unscrew all four heat sink fasteners in any order (see Letter B).
6.
Set all four anti-tilt wires on the heat sink to the inward position (see Letter C).
7.
Lift the PHM straight up off the server board (see Letter D).
8.
After removing the PHM, visually inspect that the socket is free of damage or contamination.
Caution:
If debris is observed, blow it away gently. Do not use tweezers or any other hard tools to remove
the debris.
9.
If not replacing the processor, reinstall the socket cover.
Figure 128. Reinstall the Socket Cover
a.
Squeeze the finger grips at each end of the cover (see Letter A in above figure) and carefully
lower the cover on the socket (see Letter B), then release finger grips.
b.
Ensure socket cover is locked in place.
Caution:
Do not press the center of the socket cover.
