d.
sO
undst
age
17
54. MOunt Midrange & MidwOOfer
Mount the Woofer Adapter to the door with the factory Torx
screws removed earlier. Connect the woofer wiring, making sure
the connectors lock to the speaker tabs. Use wire ties to ensure
that the woofer wiring is clear of the window mechanism! Mount
the woofer with the #8 x 1/2” black oxide screws.
Repeat the process for the Midrange, using the #6 x 3/8” screws.
55. tweeter installatiOn (Overview)
The Soundstage Tweeters install directly into the factory tweeter
mounts on the A-Pillar trim (the trim at either side of the wind-
shield). The tweeter crossover networks install in a small com-
partment on either side of the dashboard. The crossover input
connects to the tweeter wire from the amp and the 18” tweeter
pigtail connects to crossover to the tweeter.
[6SPK ONLY] The new A-pillar trim is included
56. rreMOve a-pillar triM
[R56 JCW ONLY]
Carefully lever/pry out screw cap cover (1). Remove the T-20 Torx
screw underneath. Loosen the door seal (4) to gain access to the
edge of the trim piece (3). Pull inward to release clips (2). Discon-
nect the tweeter wire and remove the the trim piece.
[6SPK ONLY] You will NOT be reusing this trim piece
[HIFI/HK ONLY] You WILL be reusing this trim piece
57. .reMOve a-pillar triM
[[R57, R58, & R59 ONLY]
Remove screws (1) and remove visor. Pull trim first down and
then inward to release clips under (2). Disconnect the tweeter
wire and remove the the trim piece.
[6SPK ONLY] You will not be reusing this trim piece
[HIFI/HK ONLY] You WILL be reusing this trim piece.
58. reMOve existing tweeter
[HIFI/HK ONLY]
Release tabs (1) and remove tweeter (2). Unclip capacitor and wire
(3) and remove.
[R56 JCW ONLY]
[R57, R58, & R59 ONLY]
[HIFI/HK ONLY]
