a.
prep
vehicle
6
1. reMOve passenger seat
Slide the seat forward. Using a Torx T-40, remove the two screws
holding the rear of the seat (1). Slide the seat backward and re-
peat for the two front screws.
2. reMOve passenger seat (part 2)
Tilt the seat back. Disconnect the airbag wiring under the seat
by pulling the black slide catch on the side of the yellow plug.
Disconnect the seat heater wiring if equipped.
DO NOT put
the key FOB in the ignition (or in the vehicle
if you have Comfort Access) while this plug is
disconnected!!
Remove the seat from the vehicle.
3. reMOve passenger seat (part 3)
If present, remove the plastic panel under the seat.
4. reMOve driver seat
[R57 with HIFI/HK ONLY]
Repeat the previous steps to remove the Driver seat.
5. reMOve left dOOr sill triM (part 1)
Using a Torx T-50 bit, remove the seat belt screw (1) where it
passes through the rear of the door sill trim.
\
see previOus step iMages
[R57 HIFI/HK ONLY]
