a.
prep
vehicle
7
6. reMOve left dOOr sill triM (part 2)
Remove metal seat belt bushing (1) if not removed in the previous
step. Pull Rear Side Trim Panel (4) in, releasing clip (3) and freeing
tab of Door Sill (2) located behind Side Panel (4).
7. reMOve left dOOr sill triM (part 3)
[Seat shown removed for clarity]
Remove the door seal over the entire length of the right door sill
by lifting it up and off. Pull up/loosen the rubber door seal gas-
ket along the length of the door. Pull Door Sill Panel (2) inward,
releasing clips (3). This requires a firm pull at each of the clip
locations. Remove the small trim piece (1) by pulling it toward
the rear of the vehicle, releasing spring clip.
8. reMOve right dOOr sill triM
Repeat the previous three steps for the Right Side of the vehicle.
9. release frOnt Of the rear seat BOttOM
Pull up firmly on the front of the edge of the rear seat bottom to
release. This will allow you access to under the carpet in later
steps
10. .pOwer & grOund wiring (Overview)
The amplifier power wiring harness is pre-assembled & terminat-
ed. 12V+ wire runs directly from the battery to the new amplifier
that installs under the passenger seat. An inline fuse is installed
at the battery.
The Ground wire runs from the amplifier to a factory-installed
common ground point along the door sill
see previOus step iMages
