e.
su
Bw
OO
fer
18
59. reMOve/replace tweeter Badges
[2010+ HK ONLY]
Remove the “Harmon/Kardon” tweeter badge by prying up gently
with a flat screwdriver. You need to insert the blade into the thin
gap between the badge and the backing plate, not between the
backing plate and the grill material. Replace with the adhesive
Integral Audio badge by removing the backing and affixing in the
recess in the tweeter grille.
60. install tweeter
Press the new tweeter squarely and firmly into the housing until
it locks into place. The “I” logo should be vertical.
NOTE: On some cars the tweeter mount may be warped, making
a very tight fit. If you can’t get all the tweeter latches to lock, use
a small dab of cyanoacrylate (superglue) at the tab location.
61. Open dashBOard side cOMpartMent
Using a panel removal tool, lever open the plastic cover on the
side of the dashboard. Run the tweeter wire coming from the
amp up the side of the door jam and into this compartment.
62. install & cOnnect tweeter crOssOver
Connect the tweeter wire from the amp to the “IN” terminals on
the tweeter crossover. Connect the 18” Tweeter Pigtail to the “T”
outputs. Route the pigtail up to the base of the A-pillar for con-
nection to the tweeter. Place tweeter crossover (1) into compart-
ment.
63. replace a-pillar
Connect the tweeter wire pigtail to the tweeter (4).Replace the
A-pillar trim (1). Take care to ensure that the tabs (3) and clips (2)
align with their corresponding holes on the vehicle, and that the
clear rubber sleeves are protecting the metal tweeter tabs. The
tabs (3) can be a little tricky - it helps to use a panel tool between
the trim and the windshield to force the tabs inward and into the
holes. Do not replace the screw and screw cover yet (wait until
after testing!)
[2010+ HIFI/HK ONLY]
