d.
sO
undst
age
14
40. Midrange/MidwOOfer speaKer wire cOnnectiOns
[HIFI/HK ONLY]
The HIFI/HK midrange/midwoofer wiring does not pass thru the
X9331 and must be spliced in at the factory amplifier under the
driver seat. Refer to chart below. Cut/strip/connect each wire
to the side coming from the car (NOT the factory amp!).Check pin
assignments (see next step) to confirm correct wires - some ve-
hicles have duplicate color pairs!! There is a label in the middle
of the midrange/midwoofer wires to identify left and right.
41. hOw tO checK hifi/hK pin nuMBers
[HIFI/HK ONLY]
Unplug the factory amplfier connector by releasing the locking
lever. Gently pry the black plastic housing out to release the lock-
ing tab.
Slide the inner connectors out of the housing. You will see the
pin numbers marked on the housing. Verify with the chart above
.
42. aMplifier pOwer & signal cOnnectiOns
Connect the Power, Ground, and Remote Turn-on Lead wires to
the amplifier.
Connect the RCA Interconnects. Set the INPUT selector on the
amp to “RCA” (2ch amp) or “LOW” (4ch amp)
Mount the Amplifier to the mounting plate using the (4) #6 x 3/8”
screws.
[SUB ONLY] Connect the RCA’s labeled “SUB” to the Rear Inputs
of the amplifier.
43. reMOve dOOr handle triM ring
Pull pin (1). Leave trim ring (2) in place, it will come off when you
remove the door panel.
[HIFI/HK ONLY]
HIFI/HK speaKeR MIDRaNGe/MIDWOOFeR CONNeCtIONs
signal
wire cOlOr
pin
cOnnect tO aMp
Front Left ++
Blue w/White Stripe
33
Front Left ++
Front Left --
Blue w/Brown Strip
34
Front
Left --
Front Right ++
Blue w/Black Stripe
11
Front Right ++
Front Right --
Bue w/Brown Stripe
12
Front Right --
[HIFI/HK ONLY]
