9
RDV-1 US/Asia 29342995
Open the battery compartment cover.
Insert the two R6 (size AA) batteries.
Be sure to match the + and – ends of the
batteries with the diagram inside the battery
compartment.
Close the battery compartment cover.
Notes
• Do not mix new batteries with old batteries or different
kinds of batteries.
• To avoid corrosion, remove the batteries if the remote
controller is not to be used for a long time.
• Remove dead batteries immediately to avoid damage
from corrosion. If the remote controller does not operate
smoothly, replace both batteries at the same time.
• The life of the batteries supplied is about six months but
this will vary depending on usage.
Inserting the Batteries
Using the Remote Controller
Point the remote controller toward the remote control
sensor.
Notes
• Place the unit away from strong light such as direct sunlight or
inverted fluorescent light which can prevent proper operation
of the remote controller.
• Using another remote controller of the same type in the same
room or using the unit near equipment which uses infrared rays
may cause operational interference.
• Do not put any object such as a book on the remote
controller. The buttons of the remote controller may be pressed
by mistake and drain the batteries.
• Make sure the audio rack doors do not have colored glass.
Placing the unit behind such doors may prevent proper
remote controller operation.
• If there is any obstacle between the remote controller and the
remote control sensor, the remote controller will not operate.
30˚
30˚
About 5 m
Remote control sensor
RDV-1(US_E)p08-09.p65
10/4/00, 17:03
9