59
RDV-1 US/Asia 29342995
4
5
6
7
Press and hold down the button on
the other remote control unit that
corresponds to the command you
want to program until the SEND/
LEARN indicator flashes twice to
indicate that the command has
been successfully programmed.
After flashing twice, the SEND/LEARN
indicator lights up again.
Repeat steps 3 and 4 to program
other commands within the same
mode.
Repeat step 2 to 4 to program
commands to the other mode.
Press the MODE button (DVD or
RECVR) that you pressed in step 2
to complete the programming.
Use the remote controller to
perform the newly learned
command to confirm that it was
learned correctly.
Notes
• Some buttons have already been programmed to control
functions of an Integra Research receiver. Therefore, it is
recommended to program additional functions of the
receiver that are not already programmed in the remote
controller.
• If no buttons are pressed for more than 30 seconds during the
programming, or if you perform an invalid operation, the SEND/
LEARN indicator flashes three times quickly and the remote
controller exits the programming mode. Resume programming
from step 2.
• If you perform an invalid operation during programming, the
SEND/LEARN indicator flashes three times quickly and the
remote controller exits the programming mode. Resume from
Step 2.
• When you want to program a command to a button to which
you have already programmed a command, simply follow the
same procedure and programming for that button will be
overwritten.
• The remote controller uses infrared rays to send its commands,
as do most other remote control units. Though most remote
control units can be memorized by the remote controller, be
aware that some remote control units use a system that is
quite different from the remote controller and therefore may
not be able to be programmed.
• Some remote control units have a single button that performs
multiple functions (for example, the function may change
each time the button is pressed). If this is the case, each
function must be programmed to a separate button on the
remote controller.
• Once you have programmed the commands from the other
remote control unit, refer to the instructions supplied with the
other component to operate.
• Make sure that both the remote controller and the other
remote control unit have new batteries. If either of them has
batteries that are low, you may not be able to program the
commands of the other remote control unit properly into the
remote controller.
• After programming another function to the
ZOOM ON
button
or
ZOOM +/–
buttons, it is no longer possible to perform the
Zoom function. To use the Zoom function again, it is necessary
to erase the commands programmed to those buttons. For
details, see page 60.
• Removing the batteries from the remote controller for at least
10 minutes erases all of the commands that have been
programmed in the remote controller.
RDV-1(US_E)p56-60.p65
10/4/00, 17:06
59