19
RDV-1 US/Asia 29342995
Sampling Rate (
@ @
)
96/88.2
48/44.1
192 /176.4
kHz
On
Standby/On
Standby
On
Power
Source
DVD
Optical
Coaxial
External Input
Open/Close
Display
Stop
Play
Video Circuit Off
O f f
PROGRESSIVE
SCAN
VECTOR LINEAR CONVERTER
Before connecting the POWER
• The RDV-1 is shipped with the main power (Power) switch in the on position ( ON). When the power cord is plugged in
for the first time, the RDV-1 will automatically enter the standby state and the STANDBY indicator will light (same
condition after step 2 below).
• Make sure that all appropriate connections have been completed as described on pages 10 to 13.
• Turning on the DVD Player may cause a momentary power surge, which might interfere with other electrical equipment
such as computers. To prevent interference, use a wall outlet on a different circuit.
2
Plug the supplied power cord
into the AC INLET and then into
the power outlet on the wall.
Notes
• Do not use a power cord other than the one supplied with
the RDV-1. The power cord supplied is designed for use with
the RDV-1 and should not be used with any other device.
• Never have the power cord disconnected from the RDV-1
while the other end is plugged into the wall outlet. Doing so
may cause an electric shock. Always connect by plugging
into the wall outlet last and disconnect by unplugging from
the wall outlet first.
4
Press Standby/On on the DVD Player
or ON on the remote controller.
The DVD Player turns on. The Standby indicator turns off and the Power
indicator lights.
The first time you turn on the DVD Player, the Initial Setup screen
appears.
Press
ENTER
, then follow the procedure on page 55 to set up your DVD
Player for the first time.
Notes
• To put the DVD Player in the standby mode, press
Standby/On
on the DVD
Player, or
STNBY
(or
ON
) on the remote controller. Be sure to set the volume to
minimum before putting the DVD Player in the standby mode for the next use to
avoid sudden loud sound reproduction.
• While the Standby indicator lights up, the DVD Player can receive signals from
the remote controller. However, if you press
Power
on the DVD Player to switch
off the main power, the remote controller cannot be used to turn on the DVD
Player.
• You can change the First Setup later with “Customizing the Function Settings”
starting from page 46.
• Setting the
Standby
button to standby does not shut off the power completely.
AC INLET
To a wall outlet
Power cord
(supplied)
1
For models with a
voltage selector, set
VOLTAGE SELECTOR to
the position of your local
power line voltage.
If the preset voltage is not correct for
your area, insert a screwdriver into the
groove in the switch. Slide the switch all
the way to the right (120 V) or to the left
(220-230 V), whichever is appropriate.
3
Press Power to switch on
the main power.
The DVD Player enters standby mode.
The Standby indicator lights up.
Notes
• The buttons on the remote controller do not
operate if the Power switch is set to OFF.
• To switch off the main power, press
Power
again.
120 V
VOLTAGE SELECTOR
220 -230 V
RDV-1(US_E)p10-21.p65
10/4/00, 17:03
19