108
≫
≫
≫
≫
≫
≫
2. Speaker
1. Configuration
Change the settings of connection environment of the speakers.
Setting Item
Default Value
Setting Details
Speaker
Channels
7.1 ch
Select "2.1 ch", "3.1 ch", "4.1 ch", "5.1 ch", "6.1
ch", "7.1 ch", "2.1.2 ch", "3.1.2 ch", "4.1.2 ch" or
"5.1.2 ch" to suit the number of speaker channels
connected.
Subwoofer
Yes
Set whether a subwoofer is connected or not.
"Yes": When a subwoofer is connected
"No": When a subwoofer is not connected
Height Speaker
Top Middle
Set the speaker type if height speakers are
connected to the SURROUND BACK or HEIGHT
terminals.
Select "Top Middle", "Top Rear", "Rear High",
"Dolby Speaker (Front)", "Dolby Speaker (Surr)",
"Front High" or "Top Front" according to the type
and layout of the connected speakers.
• If the item cannot be selected even though
connection is correct, check if the setting in
"Speaker Channels" matches the number of
connected channels.
Zone Speaker
No
Set whether speakers are connected to Zone 2
speaker terminals.
"Zone 2": When speakers are connected to Zone 2
speaker terminals
"No": When speakers are not connected to Zone 2
speaker terminals
Setting Item
Default Value
Setting Details
Bi-Amp
No
Set whether the front speakers are bi-amp
connected.
"No": When front speakers are not bi-amp
connected
"Yes": When front speakers are bi-amp connected
•
This setting is fixed to "No" if "Zone Speaker" is
set to "Zone 2".
•
This setting cannot be selected when surround
back speakers or height speakers are installed.
Speaker
Impedance
6 ohms or above Set the impedance (Ω) of the connected speakers.
"4ohms": When any of the connected speakers
have 4 Ω or more to less than 6 Ω impedance
"6 ohms or above": When the connected speakers
all have 6 Ω or more impedance
•
For impedance, check the indications on the
back of the speakers or their instruction manual.
2. Crossover
Change the settings of crossover frequencies.
Setting Item
Default Value
Setting Details
Front
100 Hz
Select the crossover frequency from "40 Hz" to
"200 Hz" to start outputting frequencies for each
channel.
"Full Band": Full band will be output.
•
If "Configuration" - "Subwoofer" is set to "No",
"Front" is fixed to "Full Band", and the low
pitched range of the other channels is output
from the front speakers. Refer to the instruction
manual of your speakers to make the setting.
