EBW-E100
Functions
45
Configuration via web interface (menu "LAN (ext)", page "Routing")
In order to configure an IPv4 default route, check the checkbox "Set
default route to gateway" and enter the default gateway behind. The
entry field is not visible in DSL operation.
In order to configure an IPv6 default route, check the checkbox "Set IPv6
default route to gateway" and enter the default gateway behind. The
entry field is not visible in DSL operation.
In order to disable NAT for incoming packets, uncheck the checkbox
"Activate NAT for incoming IPv4 packets". This may be useful in LAN
operation if the routed packets must not be changed.
In order to disable NAT for outgoing packets, uncheck the checkbox
"Activate NAT for outgoing IPv4 packets". This may be useful in LAN
operation if the routed packets must not be changed.
The router will unblock own services (e.g. DNS, VPN, NTP, etc.)
automatically with enabled firewall. If you uncheck the checkbox
"Activate NAT for outgoing IPv4 packets", the services must be
permitted manually in the firewall.
In order to add a new route, enter in the section "Add new route" the
"net address", the associated "netmask" and a gateway into the
respective fields for IPv4 or IPv6. All fields must be completed that a new
route for the respective IP version is taken over into the table. Save the
route by clicking "OK".
In order to delete an existing route, check under "Existing routes" the
checkbox of the route(s) to be deleted.
Save your settings by clicking "OK".
