EBW-E100
Functions
37
12.1.3
Entering a Static Route
You can define static routes for forwarding data packets in the EBW-E100, which
are loaded during system start.
Configuration via web interface (menu "Basic Settings", page "Routing")
In order to enter a static route, enter in the section "Add new route" the
Net address, the netmask as well as the Gateway into the respective
fields for IPv4 or IPv6. All fields must be completed that a new route for
the respective IP version is taken over into the table. Save the route by
clicking "OK".
In order to delete an existing route, check under "Existing routes" the
checkbox of the route(s) to be deleted.
Save your settings by clicking "OK".
Neither a default gateway can be entered nor NAT can be enabled or
disabled here. This is configured in the menu "LAN (ext)" on the
respective page "Routing".
12.1.4
Entering Host Names
You can specify the host and domain name of the EBW-E100 here.
Moreover, a host table can be created, in which IP addresses are combined with
host names. If the router is entered as DNS server at a PC, this can use the host
names for addressing instead of the IP addresses.
Configuration via web interface (menu "Basic Settings", page "Host names")
In order to enter the host name, enter the host name.
In order to enter the domain name, enter the domain name.
In order to enter a new host into the host table, enter in the "Add new
host" section the IP address and the associated Host name into the
respective fields. Save the host in the table by clicking "OK".
In order to delete an existing host, check under "Existing hosts" the
checkbox of the host(s) to be deleted.
Save your settings by clicking "OK".
