9
STEP 17
Coupler attachment for bikes with quick-release rear axles.
(Note: If your rear bike tire has two hub nuts please refer to Steps 15 & 16.)
17A
17B
17C
17D
17A.
Flip open the quick-release lever, and remove the nut and spring from the opposite side.
17B.
Hold the lever and pull the axle skewer with spring out.
17C. Completely remove the skewer but leave the wheel in place.
17D. Slide the coupler plate and tab washer onto the skewer. IMPORTANT! The wide end of the spring
should face out and touch the lever, the bell of the coupler plate should face out, and the tab washer
hook should face in toward the wheel hub.
STEP 18
Attach trailer tow bar to bike
18A
18B
18C
18D
18A.
Insert end of skewer through wheel hub and fit tab washer hook into slot in bike frame dropout.
18B. Replace the spring (wide end out) over the end of the skewer, followed by the nut. Tighten the nut by
hand and clamp the lever down.
18C. Insert the end of the trailer tow bar into the large hole and fasten the Q/R pin.
18D. Loop the safety strap around the bike frame and clip the end into the “D” ring at the end of the tow bar.
WARNING
Safety strap must attach to the bike frame when using this product in trailer mode.
STEP 19
Install the safety flag. Important! The safety flag is for use in trailer mode only.
19A
19B
19C
19A.
Slide the ends of the safety flag pole together so they are secure within the flagpole joiner.
19B.
Slide the bottom of the safety flagpole through the slit in the canopy down into the flagpole sleeve.
19C. Remove the handlebar. The product is now ready for use in the trailer mode.
Safety
flagpole
joiner
Safety
flagpole
sleeve
Flagpole slit
in canopy
