Taking now the front left glass, notice the black band, the wider
one goes to the top. (PICTURES BELOW) Seal lightly along the rear
edge of glass frame where it will fit into the channel and press
home to the left upright column. Repeat this right hand side.
For the latest fitting instructions please visit
www.insigniarange.co.uk
For the latest fitting instructions please visit
www.insigniarange.co.uk
23 24
Glass ready to be pressed
into place
After pressing into place
Working from inside the shower, you will notice two holes in the
bottom crossbar and the same at the top. Using the correct length
screw, screw into each hole and secure the uprights of the glass.
Bottom retaining column screw repeat both sides top and bottom.
Taking one door at a time fix wheels these will be wheel “Tyre” to-
wards the outside of the door. Button versions are at the bottom,
non button at the top Now affix door handles inner and outer. Tak-
ing a magnetic trim place firmly on the outer edge of the door end
as it will close. Repeat the procedure on the other door. Note:
Make sure magnets attract not repel! On the trailing edge of the
door fit steam escape trims with the flexible end to touch Alumin-
ium upright when in closed position. Taking one door, clip into the
top runner and press buttons in the bottom wheels to clip into the
lower runner. Repeat for second door. Check alignment of doors by
closing them. Do they firmly seal all the way from top to bottom? If
so they are fitted correctly, if not you need to adjust them. Adjust-
ment is made by turning the screw heads found in each wheel fit-
ment. Screw in at bottom outer wheels to close gap at top and vice
versa. If the door looks as if it is too loose in runners tighten top
and bottom equally checking that both run smoothly. When this
operation is done take the four door stops and fit one at a time to
each of the predrilled holes found in the top and bottom door run-
ner crossbars.
