www.insigniashowers.com
Last Modified: 06/05/2022
11
w ire p ip e
c ontrol w ire
c ontrol w ire
w ire p ip e
housing b ox
KSA-EA
c ontroller
w all
Ceiling
w all
Tem p .sensor
b ox
M 4
self-tap p ing
screw
1.
The control wire and temperature wire should not be parallel to the
power wire.
2.
The control wire and temperature wire should not intersect with the
power wire.
3.
The temperature sensor should
NOT
be installed on the side of the wall
which is behind the door.
4.
The temperature sensor is used to measure the temperature inside the
steam room, so that the generator can work automatically according to
the pre
-
set temperature and maintain a constant room temperature.
5.
The installation height of the sensor should be approx. 1.2 –
1.5
m from
the ground.
6.
Drill a hole (diameter 16mm), and screw down the sensor in the steam
room.
7.
Pull the sensor wire through the conduit then connect into the central
function box.
Installation of temperature sensor
