Inova WallBed, Инструкция по сборке

Страница: 54 / 57

Tech support is readily available if needed
Email: support@inovabed.com
Phone:
866.528.2804
WallBed
| ASSEMBLY MANUAL
PLEASE NOTE: Your Bed may look different
than what is shown in the pictures and
videos throughout this manual
TROUBLESHOOTING
HOW CAN I ACCESS
BEHIND THE WALLBED?
If you need to access to the area behind the
bed, you most likey do not have to remove it
from the wall. The Headboard does release,
allowing access behind the Bed.
TO LOWER THE HEADBOARD:
Have someone lower the bed about halfway
and hold it there. On the back of the
Headboard there are guide pins located on
the left and right, with a cable stretched
between them. These pins extend into the
track located on each side of the cabinet,
guiding the Headboard movement as the
bed is raised and lowered. Reach behind
the Headboard and locate the cable. Pull
the cable upward to release the pins on
both side and pivot the Headboard forward
to the mattress. Make sure you keep
holding tension on the cable as you pivot
the Headboard to prevent the pins from
scratching the inner faces of the Cabinet
Sides. At this point, the Bed can be lowered
down completely. To re-engage the pins,
pull upward on the tension cable and raise
Headboard, until the pins are aligned
with the track. Release the cable. The pins should snap out into position, resetting the
headboard for use.
REMOVING BED FROM WALL:
With another person, “walk” each side of the
Cabinet away from wall.
TIP: You may want to place moving pads
underneath cabinet (with another person,
tip cabinet slightly to place pad).
MY WALLBED IS MAKING A
CREAKING NOISE
If any of the hinges or other parts of the
mechanism on the WallBed creak, spray