INOVA AUTOMATION
NICE Series Integrated Elevator Solution
–
N Quick Start-Up Guide V1.0
32
Lift starts
to run with
Inspection speed
towards up terminal floor
.
On detection every Floor Level/Door zone Fag/Plate, the floor counting will increase on MCB display
On detection of up terminal floor level/Door zone switch signal, Lift stops and Shaft learning gets completed
During auto learn, N system measures the shaft travel distance using Encoder feedback
Counts the number of floors using Floor level/Door zone switch signal and stores counted encoder pulses in the
form of bits in F4 Floor parameters
On completion of auto shaft learning without any Error, operating LED keypad displays the normal status.
(Note: If Err35 comes during shaft learning, refer the Error history for remedies and re-do the shaft tuning)
6.2
Door operator commissioning
6.2.1
Auto door DOL and DCL
‘
NO
’
type feedback status on MCB of N for different door position
Doors Fully Closed
Doors Fully Opened
Doors in-between
6.2.2
Auto Door Setup
N system is capable for double side door operator system (Front and Back Doors)
Door Open Limit and Door Close Limit switch feedbacks are mandatory for N system function (to
be connected to X14 and X18 Default input terminals for Front door)
If the third party door drive system is used, follow the door drive commissioning instruction and commission
the door drive along with N input and output interconnections as shown in above model wiring
diagram
Follow the commissioning procedure provided by door operator system supplier
D
OL
DCL
+
24
V
dc
X
14
X1
8
+
24
V
dc
ON
OF
F
MC
B
DO
L
DC
L
+
24
V
dc
X
14
X1
8
+
24
V
dc
OF
F
ON
MC
B
DO
L
DC
L
+
24
V
dc
X
14
X1
8
+
24
V
dc
OF
F
OF
F
MC
B
