INOR IPAQ C520, Дополнительное руководство по инструкции

Страница: 10 / 28

4
SAFETY FUNCTION
10
IPAQ C520/R520
www.inor.com 02/2019 - 86B520S001 - AD 520 SIL R1.4 en
4.3.1 Sensor drift
If the function "Sensor drift" monitoring is selected, a difference between the sensors of more or
equal to the value stated in the configuration will cause the output to go either "Downscale" or
"Upscale" depending on the user configuration. Maximum temperature difference has to be
specified in
° C via ConSoft.
4.3.2 Sensor backup
If "Sensor backup" function is activated the sensor chosen as output measuring in the
configuration will reflect the actual measuring value as long as it
’
s working properly. A sensor
break or a sensor short cause the transmitter to switch over to the other sensor and the output
signal will reflect the measured value of that sensor. A diagnostic message is transmitted via
HART
®
to the PLC.
If the "Average" function is activated in the configuration, the output value will reflect the actual
mean measuring value as long as the sensors are working properly. A sensor break or a sensor
short cause the transmitter to switch over to the non-broken sensor and the output signal will
reflect the measured value of that sensor. A diagnostic message is transmitted via HART
®
to the
PLC.
The functions "Sensor backup" and "Average" doesn't give any extra safety according to SIL and
are not used for calculating the system (trans sensor) safety figures.
CAUTION!
The possibility to select the function for sensor drift monitoring is implemented in software
revision IPM-SW 01.01.03 and OPM-SW 01.01.04, from serial number 1006.xxxxxx.