NV10 FAMILY USER MANUAL
Copyright © Innovative Technology Ltd 2016
Doc: GA02116 - NV10 FAMILY USER MANUAL
Version:1.1
Page 17 of 80
5
SOFTWARE INSTALLATION AND CONFIGURATION
5.1
Introduction
The NV10 USB/+ leaves the factory pre-programmed with the latest dataset and
firmware files. However, it is important to ensure your device is kept up to date with
the latest dataset and firmware. This section will give you a brief overview of the
various update possibilities with the NV10 USB/+. For detailed instructions please
refer to the relevant manual package supplied with the software or contact
5.2
Software Downloads
All software from Innovative Technology Ltd is free of charge and can be
downloaded from the website
www.innovative-technology.com/support/secure-
once registered and logged in. If you are not registered, please create an
account via the Create an account form. A confirmation email will be sent to the
registered email address once all contact details have been successfully submitted.
As of June 2016 the ASIIC chip used in the NV10 was made obsolete by the
manufacturer. As such a new board revision with a different processor was released.
This resulted in a different hardware revision and firmware version, please see
below:
The NV10 with ST chipset will have its own ‘validator type’ referenced in the dataset
name (see below in RED):
Previous NV10
–
EUR10
6
50
NV10 with ST chipset - EUR10
H
50
Ensure the correct version of firmware is being used for the product.
5.3
Drivers
The ITL drivers allow you to connect any of our validators to a compatible Windows
device. If you are connecting via an IF17 then you will not need to follow this
process as they are signed Microsoft Drivers and should install automatically. If this
isn’t the case or your computer is disconnected from t
he network, there is a
standalone package included within the driver downloads.
