Innovative Concepts in Entertainment Ice Ball, Руководство владельца и по обслуживанию

Страница: 15 / 18

15
GAME REPAIR
BALL RETURN SENSOR
Turn off game power.
Open cash drawer at least 6 inches.
Slide ball release cover from right hand side of game.
Sensor assembly is located at the rear of the ball return
channel where the 2 cabinets meet.
Unscrew the sensor assembly and remove.
Assemble in reverse order.
NOTE: BE SURE THE TRANSMITTER WIRING IS
KEPT HIGH ENOUGH FOR THE BALLS TO PASS
UNDER. IF THERE IS ANY SLACK, IT IS
IMPORTANT TO REMOVE IT USING A TIE WRAP,
ETC.
SCORE SENSORS
Remove all A.C. power from the game.
Remove the 6 screws from the front of the cage and
remove the front of the cage.
Remove the single screw from the bottom of each cage
side and remove the sides.
Remove the 2 retaining screws on the playfield.
Remove the playfield.
Re–connect power to the game and put the game in test
mode.
Run your hand through each sensor pair and listen for the
sound to indicate proper function.
If the sensor does not indicate proper function, remove the
sensor and replace.
Re–assemble in reverse order.
Re–test the assembly when finished.
MAINTENANCE
Maintenance is easy as the game requires very little
service under normal use. To get the best out of the game,
please perform the following as indicated:
Clean the playfield weekly using Wildcat pinball
cleaner.
Clean the playfield once every 3 months with a
buffing wheel and Novus polish.
Oil the levers and linkages on the release system
every 6 months.
Polish the cabinet with a good grade of spray
furniture polish every 6 months.