Shutting Down the Terminator 2100PRO
Note:
The T-2100PRO is equipped with a LPG engine that may run on several seconds after the key is
switched to the off position. This is a normal function of the engine control system running fuel out of the
vapor hose to prevent engine backfiring on restart. The engine may run up to 5 seconds after the key is
switched to off.
1.) Release the drive control levers.
2.) Lower the blade to the floor.
3.) Reduce the throttle to idle speed.
4.) Turn the ignition switch counter-clockwise to the OFF position.
5.) Turn the propane tank control off turning the valve clockwise.
6.) Inspect the machine for damage.
7.) For safety, remove the propane tank and key.
Taking Up Floor Coverings
1.) Insert the blade. (Refer to Blade Assembly below.)
2.) Lower the blade to the floor. As the blade flexes lift the caster wheel off the floor about ¼ inch.
3.) Drive the machine forward.
4.) As the Terminator 2100PRO is removing flooring material have another person at the side of the
machine, remove all debris.
Blade Assembly
Blades are available in different configurations and thickness. An assortment of blades is included in the
purchase price of the Terminator 2100PRO. Extra blades are available upon request from Innovatech
Products & Equipment Co., Inc.
1.) Raise the blade assembly to the maximum up position, which is four inches off the floor.
2.) Unwrap the pre-sharpened blades and select the blade thickness and length you need for the job.
3.) Loosen the seven holding bolts.
4.) Insert the sharpened blade with the beveled side up.
5.) Tighten bolts firmly, starting from the center and working out. Bolts should be snug but not over
tightened.
