Uncrating and Preparing the Terminator 2100PRO for Operation
1. Inspect the outside of the Terminator 2100PRO crate completely upon delivery. Notify the carrier
if the crate is damaged.
2. Carefully uncrate the machine and inspect it for damage that may have occurred during shipping.
If the shipment is damaged, notify the carrier immediately.
3. Remove the crate debris, set aside the blades and other packages.
4. Follow the instruction to remove the Terminator 2100PRO from the crate.
Remove the Terminator 2100PRO from the Crate Using a Forklift
WARNING: Use the forklift slots to lift the Terminator 2100PRO.
Remove the Terminator 2100PRO from the Crate Manually
1.) Install a full propane tank.
2.) Remove the 2 x 4’s from the edge of the crate and from between the wheels.
3.) At the rear of the machine, create a ramp using the 2 x 4’s and crate material.
4.) Start the Terminator 2100PRO.
5.) Lift the front wheel off the crate by approximately five (5) inches. The jaw will be on crate.
WARNING:
Keep feet from the area.
6.) Pull up on both control levers and move both levers back slowly. The machine will start moving
slowly backwards.
7.) The jaw will roll back on the ramp. Both wheels must to come off evenly.
WARNING:
Roll the machine straight back to prevent rolling.
8.) As the machine rolls back, make sure the center wheel clears the crate. Use the blade height
switch to lift the wheel higher as needed.
9.) Once the machine is on the ramp, slide the machine all the way to the bottom.
10.) Lift the jaw and set the center wheel to the ground.
*
ALWAYS
turn OFF the engine when mounting or dismounting the Terminator 2100PRO.
Loading/Unloading Procedures
•
Do not load or unload the Terminator 2100PRO on uneven ground. Make sure ramps are square
to the ground.
•
Always turn the engine OFF when transporting the Terminator 2100PRO by forklift or other
vehicle.
•
Load and unload the machine using a properly weighted forklift or lift-gate.
•
Make sure all safety stops are installed when using a lift-gate.
•
Never position personnel under or around the machine while moving it with other machinery.
•
Park the machine with the blade completely down after loading.
•
Properly secure the machine with chains, tire chocks, and other necessary tie downs.
•
Never ride on or near the Terminator 2100PRO during transportation. It may tip, causing severe
injury.
Inspect the lug nuts on the rear wheels; tighten the nuts to 70 inch-pounds torque.
Raise the hood.
