Ballast
The Terminator 2100PRO is equipped with 540 pounds of removable ballast. These ballast weights are
located in front and rear to provide traction. Remove these weights to reduce traction and to transport the
Terminator 2100PRO by forklift, truck, or elevator. Wear gloves when handling weights.
WARNING:
Dropping or mishandling the ballast weights may cause personal injury or damage to the
equipment.
Removing and Installing Front Ballast Weights
Caution:
Remove one side of ballast at a time to avoid damage or injury.
Caution:
Ballast weights are heavy. Use a lift or a two-person team when lifting the ballast
weights.
Removal
1. Remove the two ½” bolts holding the ballast on.
2. Carefully remove the weights.
Installation
1. Make sure that the area of installation is clear of debris.
2. Carefully place the weights ensuring proper alignment of the bolt holes.
3. Install the ½” bolts in the holes on the ballast. Tighten the bolts.
Figure 2 Front Ballast
