Innovate Technology NV10, Руководство по эксплуатации

Страница: 9 / 39

NV10 Operations Manual – GA333-3
9 of 38
© Copyright Innovative Technology Limited 2005
Interface Switch 3 Switch 4
Parallel Down Down
Pulse Down Up
SSP Up Down
Special Up Up
Table 1 – Switch 3 and 4 Machine Interface Selection
The details of the parallel, pulse and SSP can be found in the machine interface protocol section of
this manual.
The special interface depends on the firmware that is used in the NV10, the firmware shipped as
standard is the binary interface (World Wide) and CCTalk (UK only). However there are other options
that can be downloaded by the user:
•
CCTalk.
•
ITL Simple serial I/O.
•
Binary
•
MDB
Information on each of these interfaces can be found in the ‘machine interfaces protocol section’ of
this manual.
5.2: LED status codes.
The three status LED’s are located to the left of the DIPswitches on the right hand side of the unit
and are used to indicate a variety of status signals.
The red status is used to indicate system problems, while the green status indicates system health,
these are described below in table 2.
LED Status Description
Slow flashing green led Heartbeat
(Slow = 1 second period)
In normal RUN operation, when the NV10 is ready to
read a note, the green status led will flash slowly
("Heartbeat") to signal a “healthy” status.
Flashing red one second period NV10 is jammed, somewhere in the note path
Fast flashing red (fast = half second period) NV10 cannot calibrate, sensor(s) may be blocked
Permanent Red Memory has been corrupted
Flashing amber and bezel lights Power supply is incorrect, check specification
Table 2 - LED Status Codes
.