Innovate Technology NV10, Руководство по эксплуатации

Страница: 10 / 39

NV10 Operations Manual – GA333-3
10 of 38
© Copyright Innovative Technology Limited 2005
6: Machine Interface: Hardware.
The NV10 interface connector is located on the left side of the unit. It has 16 pins (see figure 3), two
are used for the 0v and +12v power supply and there are five outputs and five inputs, the remaining
four pins are reserved for future use. An example mating connector is Molex Part No: 39-51-2160
Figure 3 - Interface Connecter
6.1:Interface Connector Pin Details
The interface connector pins details are described below (see table 3); they have a 0.1" pitch header
with 2 rows of 8 pins.
Pin Name: Description:
1 Vend 1 (binary bit
1)
Note accepted on Channel 1,
Also the Pulse Stream output
Also the serial output pin in SSP and other serial modes
2 Vend 2 (binary bit
2)
Note accepted on Channel 2 pulse output
3 Vend 3 (binary bit
4)
Note accepted on Channel 3 pulse output
4 Vend 4 (binary bit
8)
Note accepted on Channel 4 pulse output
5 Inhibit 1 Inhibit channel 1 by holding this pin HIGH. To Enable a channel
the inhibit must be held LOW.
Also the Serial Input pin for SSP and other serial modes.
6 Inhibit 2 Inhibit channel 2 by holding this pin HIGH
7 Inhibit 3 Inhibit channel 3 by holding this pin HIGH
8 Inhibit 4 Inhibit channel 4 by holding this pin HIGH
9 Busy NV8 is validating and stacking output. Active low while the NV8 is
reading, transporting or stacking a note.
10 Escrow Operate Escrow function by holding LOW, refer to Escrow section
in parallel and binary modes and Appendix D for full details
11 Spare Spare
12 Spare Spare
13 Spare Spare
14 Spare Spare
15 +Vin Nominal 12V DC supply
16 0V 0v Supply
Table 3 - 16 Pin Connector Details
Interface Connector