Innotech Omni C14, Руководство по установке

Страница: 12 / 90

Omni Installation Instructions
Page 12 © Mass Electronics Pty Ltd 2017 Edition 1.2 dated 16.08.2018
1-1 Introduction
This manual is intended to provide qualified technical personnel with complete and easy-to-follow
instructions for the installation and commissioning of the Innotech Omni BEMS controller and
associated devices.
Although the intent of this manual is to simplify the installation task, instructions contained in this
manual are based on the assumption that installation of an Innotech Omni Control System will be
accomplished by technically qualified personnel. Also, these instructions assume that installation
personnel are familiar with local regulations, codes and safety requirements.
Installers should familiarise themselves with the content of this manual before attempting
installation of the Omni Controller or associated devices in the Omni family.
Throughout this manual there are icons to illustrate notes and points of caution, as illustrated below:
These notices contain critical information, which
MUST
be read. Ignoring instructions in these notices could result in
damage to person or controller.
CAUTION
These notices contain information about the software that must be done before proceeding further to ensure
success.
IMPORTANT
These notices indicate a piece of useful information which should be read.
1-1.1 Systems Covered by this Manual
Systems are intended for use in a variety of applications, the systems are designed on a modular
basis. This flexible system provides the most economical and efficient means of adapting the system
to the customer’s specific requirements.
The manual covers the Omni System. This system is based on one or more controllers as the major
control units interconnected with several ancillary units. These major control units included in this
manual are:
• Omni Controller (all models)
• Omni U10 Remote Expansion Module
For purposes of explanation, a System is defined as one or more controller units interconnected with
various ancillary units for the purpose of performing specific functions. An Omni system consists of
one or more Omni Controllers as the major control unit(s).
The purpose of this manual is to provide clear and complete instructions for all phases of the
installation of the devices that comprise your Omni System. In order to provide the clearest
instructions possible with minimum confusion, instructions in this manual are based on the following
approach:
• For simplicity of explanation, installation instructions in this manual are based on an Omni System
containing a single Omni Controller.
• Basic electrical wiring information is provided in the Electrical Installation chapter, and wiring
instructions for network systems are contained in the Network Installation chapter.