21
GB
detected temperatures. For example, if you
set 1.0 °C, at the end of the measurement,
the thermometer will show the measured
tempe 1.0 °C on the display.
• Memory search: press the ‘+’ or ‘-’ button,
the display will show the previous 32
measurements specifying the detected
value and the memory references (from
‘M01’ to ‘M32’).
Measuring again: If you want to measure
the temperature again, repeat the step 1
and step 2.
Note: The time between each reading
should be not less than 1min.
N.B: If the display shows “Err” (Fig. L) it
means that the operating environment
temperature is higher or lower than
indicated.
• Automatic switch-off: The thermometer
switches off automatically after 1
minute of inactivity. You can turn off
the thermometer manually by pressing
and holding the SET button for about 4
seconds.
Important: The area temperature differs
from the internal body temperature. To
obtain the internal temperature always
use the body mode. Please make sure
to select the body mode for an internal
temperature reading and the surface
temp mode for an external area reading.
