34
VIEW 5 Pro
Fiber Axis Align Failed
Axial offset （>0.4um）
Prepare the fiber (stripping,
cleaning, and cleaving) again.
The motor is not calibrated
Do the “Motor Calibration” maintenance.
Fiber is Dirty
There’s dust or dirt on the fiber
surface
Prepare the fiber (stripping,
cleaning, and cleaving) again.
Dust or dirt is on the lens or LEDs
Execute the “Dust Check”. If dust or dirt exists, clean the lens-
es or LEDs
“Cleaning Arc time” is too short
Set the “Cleaning Arc time” to 180ms
Splice the fibers whose cores are
difficult to find by the way of core
alignment.
Splice the fibers whose cores are difficult to find by MM splice
mode (cladding layer alignment).
Fat Splicing Point
Too much [Overlap] setting
Adjust or initialize “Overlap” setting.
The motor is not calibrated.
Calibrate the arc power with the “Arc Calibration” function.
Thin Splicing Point
Inadequate arc power
Calibrate the arc power with the “Arc Calibration” function.
Pre-fuse power or time is set too
high
Adjust or initialize “Pre-fuse Power” or “Pre-fuse Time” set-
tings.
Insufficient “Overlap” setting
Adjust or initialize
“Overlap” setting
