Using the LCD and Keypad
3004149-0001 Revision B
19
Multiple Users
Multiple TEs can be connected to the 9202, e.g. via the wireless
LAN interface or if an external hub or switch is used. To use the
menu and keypad to control connections for all the TEs, press
the User button and the display will cycle through the IP
addresses of the connected TEs.
To activate a context for a particular TE, press the user button
until the correct IP address is displayed, and then press the
Accept button to enter the menu and control the PDP context.
Information Messages
The following table shows possible error and status messages
with explanations and suggested actions. Most of these
messages will self-clear after 15 seconds, or can be cleared
immediately by pressing any button on the front panel.
When setting up contexts from the menu, these messages are possible:
MustDeact1st
There is already a context up for this TE, deactivate it before setting
up a new one
Deact;TryAgn
UT is in the process of deactivating a context, try setting up the
context a short time later
NotPSAttachd
UT is currently not PS attached, context setup is not possible
No TE Found
There is no TE currently connected/identified by the UT as available
for data traffic
Activating..
The UT is now attempting to establish the requested context; this
message appears until the context is setup or an error is detected
When taking down contexts from the menu, these messages are possible:
Deactivating
The context is being deactivated; this message appears until the
context is deactivated or an error is detected
NoCntxtActiv
The TE for which context deactivation is being requested doesn't
have a context setup at this time
When sending SMS messages from the menu, these are possible:
NotCSAttachd
The UT is currently not CS attached, so it cannot send an SMS
message at this time
Sending SMS
The UT is sending the requested SMS message
SMS Sent
The UT has sent the requested SMS message
SMS Failed
The UT failed to send the requested SMS message
If in pointing mode, this message is possible on the LCD:
Insert SIM
There was no SIM detected; pointing can still continue, but once
complete, "No SIM" will appear permanently and only emergency
calls can be made (this message remains on for about 1 minute,
then self-clears)
If changing the Telephony settings, this message is possible on the LCD:
