INIM SmartLoop Series, Руководство по программированию

Страница: 38 / 44

38 Operating the system
Programming manual
Chapter 11
Operating the system
Only persons responsible for the safety of the building and its occupants (level 2) can operate the system
after entering a code or inserting the key in the keyswitch.
These operators can access the functions described in this chapter.
11.1 Changing Day/Night mode
This option allows operators to change manually the Day/Night operating mode of the control panel.
From panel:
<key>, Panel settings, <code>,
or:
<key>, 3, <code>
Use keys
S
and
T
to change the operating
mode.
Note:
If you require automatic control of the Day/Night operating mode, you must set a timer.
11.2 Bypassing/Unbypassing devices
Under certain circumstances (e.g. maintenance or fault conditions), it may be necessary to bypass a zone,
a point, an output or the entire loop.
Bypassed elements cannot generate fault or alarm signals and cannot be activated. The SmartLoop control
panel provides a programming menu which allows users to bypass and unbypass the various system
elements.
One you have accessed the menu relating to the element you wish to bypass/unbypass, refer to the
following section.
1. Use keys
S
and
T
to navigate through the elements.
2. Use keys
W
and
X
to enable or disable the selected element.
3. Press Esc to confirm the operation and step back to the previous menu.
11.2.1 Bypassing/Unbypassing a device
From panel:
<key>, Disable, <code>, Loop Devices, x Loop x, yyy device,
or:
<key>, 4, <code>, 1, x, yyy
11.2.2 Bypassing/Unbypassing a zone
From panel:
<key>, Bypass, <code>, Zone,
or
<key>, 4, <code>, 2
C o n t r o l p a n e l m o d e : D a y
P o i n t x / y y y < D e s c r i p t i o n >
< D e v i c e T y p e >
S T A T U S : _ E n a b l e d
KL
= S e l e c t P o i n t
IJ
= E n a b l e / D i s a b l e d