INIM SmartLoop Series, Руководство по программированию

Страница: 15 / 44

Programming manual
Programming the control panel 15
Chapter 6
Programming the control panel
The SmartLoop control panels accept different configuration and programming methods which can be
combined to suit particular installation requirements.
6.1 Panel printer
If you are working on a particularly difficult installation with console-equipped control panels (i.e. control
panels with keypads and displays), you can install the system (control panel, attachment boards, loop
devices, etc.), then instruct the control panel to assign addresses to the loop devices automatically. Once
this phase has been completed, you can upload the data to your computer and use it for the successive
programming phase, or proceed with programming from the control panel.
The configuration/programming operations via control panel are reserved for the installer company
technicians (level 3), who can:
1. By means of a screwdriver or similar tool, remove the screws and open the panel enclosure.
2. Place the programming jumper in the correct position (refer to paragraph 4.2 - [N] in the installation
manual). The control panel comes with the jumper already inserted (factory setting).
3. Access the Programming menu.
4. Type in a code which allows access to the programming phase.
Note:
The access PIN is “
00004
” at default.
Operators with authorization to use this code can access all programming and maintenance functions.
Attention:
Some programming functions cannot be accessed through the control panel.
6.1.1 Accessing the main menu
Once you have placed the jumper in the
correct position, select the
Programming
option from the main menu.
Type in a code which allows access to the
programming phase (level 3 access).
If the jumper is not connected properly, the
display will show the respective message.
Note:
Access to the programming phase from a computer will not be allowed unless this jumper is connected
to the control panel.
5 D i a l l e r s e t t i n g s
6 P r i n t e r S e t t i n g s
7 M a i n t e n a n c e
J
8 P r o g r a m m i n g
L
E n t e r C o d e
- - - - -
I n t e r n a l P r o g r a m m i n g j u m p e r
N O T i n s e r t e d ! ! !