INIM SmartLoop Series, Руководство по программированию

Страница: 16 / 44

16 Programming the control panel
Programming manual
6.2 From computer
If you prefer to plan the layout of the system beforehand, or if you are working with control panels which
are not equipped with keypads and display, you can prepare the system layout and/or set parameters
without leaving your office. The data can be downloaded to the system later.
For further details refer to the SmartLeague programming software.
6.2.1 Enabling programming via PC
All functions can be accessed without connecting to the control panel; connection is necessary only for
upload and download operations.
1. By means of a screwdriver or similar tool, remove the screws and open the panel enclosure.
2. Place the programming jumper in the correct position (refer to paragraph 4.2 - [N] in the installation
manual). The control panel comes with the jumper already inserted (factory setting).
3. Connect the computer to the RS232 or USB port. The connection cable must be long enough to reach
the mounted device without difficulty (refer to the installation manual, paragraph 7.13 - Connecting to
a PC ).
4. Start the SmartLeague software application.
5. Type in a code which allows access to the programming phase. On startup, the Installer or Maintenance
access code (level 3) is already set.
Note:
It is advisable to program the entire system via computer and use the control panel for minor changes
only.
6.3 From remote computer
If you are working on a console-equipped control panel (i.e. control panel with keypad and display) from a
remote location (for monitoring or software maintenance purposes), you can set up the control panel for
programming, connect to the Internet and, using a password-protected virtual control panel, carry out the
desired operations.
6.3.1 Initializing remote programming
The programming and maintenance operations are the same as when using the SmartLeague software
application. However, it is necessary that:
• the programming jumper is placed in the correct position (refer to paragraph 4.2 - [N] in the installation
manual).
• the SmartLAN or SmartLAN/SF board is configured to allow Internet access.
Accessing remote programming:
1. Connect to the Internet.
2. Open the Internet browser and enter the IP address of the control panel.
3. Enter the Access Code
Refer to Chapter 9 - Programming the local network (SmartLoop\NET) .