Inglesina Aptica Series, Инструкция по эксплуатации

Страница: 34 / 176

34
EN
HINTS FOR CLEANING THE TEXTILE LINING
• It is recommended to wash the lining separately from
other items.
• Periodically revive the fabric parts using a soft clothes
brush.
• Follow the lining washing instructions on the labels.
Handwash in cold water
Do not bleach
Do not tumble dry
Dry flat in shade
Do not iron
Do not dry clean
Do not spin-dry
• Dry the textile lining completely before using or storing it.
• To prevent formation of mildew, it is advisable to air the
carrycot periodically. In particular, separate the textile lining
from the structure and run a dry cloth over the bottom.
LIST OF COMPONENTS
fig. 1
APTICA STANDARD CHASSIS
A
Rear wheels
B Rear axle
C Front RH wheel assembly / Front LH wheel assembly
APTICA XT CHASSIS
D
Rear wheels
E Front RH wheel assembly / Front LH wheel assembly
APTICA CARRYCOT
F
Hood lining
G Carrycot apron
STROLLER
H
Stroller seat
I Handrail
J Hood
ACCESSORIES
K
Feeding bottle holder
L Storage basket
M Muff (if available)
N Rain cover (if available)
INFANT CAR SEAT (if available)
APTICA STANDUP (if available)
CHASSIS
OPENING THE CHASSIS STRUCTURE
fig. 2
Holding the lever ( O ) down, lift the chassis firmly
until it opens completely.
fig. 3 Caution: make sure that all closing mechanisms
are properly attached on both sides before use.
STANDARD VERSION
ASSEMBLING/REMOVING THE REAR WHEELS
fig. 4
Insert the rear axle ( B ) in both of the rear tubes ( B1 )
of the chassis and push it into its housing.
fig. 5 Caution! Ensure that the rear axle ( B ) is attached
correctly, making sure that both the pins ( B2 ) are in their
housings.
fig. 6 Insert the rear wheel ( A ) on the rear axle ( B ) and
push it into its housing until it clicks correctly into place.
Proceed in the same way for the other wheel.
fig. 7 Caution: make sure that the wheels are properly
attached before use.
Should it be necessary, the rear wheels and rear axle can
easily be removed.
fig. 8 Operate the lever ( A1 ) and detach the rear wheel
( A ).
fig. 9 Holding down the pin ( B2 ), remove the rear axle ( B )
from the chassis tube.
XT VERSION
ASSEMBLING/REMOVING THE REAR WHEELS
fig. 10
Insert the rear wheel ( D ) on the rear axle ( B ) and
push it into its housing until it clicks correctly into place.
Proceed in the same way for the other wheel.
fig. 11 Caution: make sure that the wheels are properly
attached before use.
Should it be necessary, the rear wheels can easily be removed.
fig. 12 Operate the lever ( D1 ) and detach the rear wheel
( D ).
STANDARD VERSION & XT VERSION
ASSEMBLING/REMOVING THE FRONT WHEEL ASSEMBLY
fig. 13
The front wheel sets for both the STD version and
for the XT version are divided into RH (right) and LH (left)
and can be easily identified by the reference ( W1 ) stamped
at the fastening peg. The same reference ( W2 ) is also printed
on both front chassis supports.
fig. 14 Insert the front wheel assembly ( C/E ) in the
corresponding front chassis support, until it clicks correctly
into place.
fig. 15 The hole ( W3 ) on the wheel assembly and always
kept on the outside helps to identify correct RH and LH
correspondence between wheels and chassis more easily.
fig. 16 Caution: make sure that the wheels are properly
INSTRUCTIONS
T
T